Define the shape and curves of silver earrings.

The shape of the silver earrings :

Suppose you don’t want those jagged little pieces going through your ear. So it would be best if you made it nice and smooth. So those silver earrings are comfortable to wear; you take off the top bit for starters. That is probably the bit that takes the longest. Because you have to do all four ends, you want to ensure that you get a nice round, a smooth cap on top of this. If you can see, do the top and go on an angle around so smooth it out. As you go, they end up and how you test it. Honestly, you just run your finger over it and know if you can’t feel any bits of that.

This one is smooth and ready to go, so they’re almost done; you want to give you another tip: slowly spin it around in your fingers. If you were filing and so, that kind of keeps it, and even around you just wanted to know if that was visible Earlier. They now got two pieces that are done, and you want to check again that they’re the same length.

Because sometimes, when you file them down, they are slightly different lengths, and you want them to be as even as possible. So that the final pair of silver earrings are the same as possible, the next step is to make the shape of the spiral using silver. So, you need your round nose pliers to give us the starting point. So you get right in there and what you want to do is you want to take it right close to the tip of the pliers.

The natural curve of silver earrings :

If you want to see how there’s a natural curve in the silver earrings, you want to make sure that you follow that natural curve rather than fighting against it. Because you know it was in this big loop, they want to not fight against that natural curve. They want to go with it because they’re making a curved pair of Earrings; if you are going to take that and make a small loop so step one is to make that initial loop, and you want to make that reasonably tight if you want to keep going making the spiral from here, so the idea is to use the other end and slowly pull it around until you get the excellent spiral shape.

This will take some practice; you might end up with a bit of a mess the first time you do it if you’re making this jewelry. You always recommend buying some brass or copper of the exact dimensions at one millimeter, and you can always experiment with that First. Now they’re going to be a bit softer than silver, so you be aware of that, although soft silver is similar. So you can experiment and make designs in much less expensive metals before you use silver. So that could be a thing to do as well; you’ve made the loop now, you want to do what You want to do this so you can better see what they are doing here and take this loop here; you’re going to hold it with your pliers and slowly going to spin it. If you can see how slowly spinning it into that shape and your twist pliers. If you spin it and do that, you are spinning with your hand.