I have tried many times to fix drywall of my own but still, I need some more ideas to make better drywall.

When your room or hall is ready for drywall work you should be more careful in doing drywall works. These are some of the simplest ways to install drywall and Drywall screws  in your room. Before starting your work your work should be planned before it is started. The first important step in drywall is planning. Without a plan, you can do your work perfectly because if you have any doubt in the middle of your work your plan helps to remain you. Start measuring the wall and ceiling surface and mark it down. Then fix whether the panels are to be fixed vertically or horizontal. Always remain that your goal is to have the least number of joints. Normally when you install a panel always try to fix it horizontally.

Then the second step is to apply the panel in the right position. Before that, every panel should have a nice and clean edge so place the panel with light and colored side up then measure the area according to your plan. With the help of sharp and as well as T-square utility knife mark only that you can see the market place again. To break the core, panel edges and the grasps snap the board quick firm movement away from you. Repeat the process for all the sides and once you complete the panel by running the utility knife through the back paper.

And finally, attach the panels. When you attach drywall whenever it is possible to attach the ceiling panels first and fasten the farming of the perimeter and joints in ceiling by using the drywall screws. Place the screws for every 12 inches from one another. The distance between the screws can be adjusted according to your measurements. The Head of the screw should be driven slightly below the face of the drywall panel. But note that if you make a deep hole in it sometimes it may break the drywall paper. If the ceiling is completed apply your panel on first top and place it in the below region. Before placing the lower panel make sure that the top edge is uptight ceiling against the panel. Here you can fix the screws with a distance of 16 inches between them. When you install the top panels avoid having the joints above or below the corners of the doors, windows, or other openings. By this process, you’ll reduce the chance of cracking that occurs in the finished walls.

While installing your panels always used to leave a gap of half-inch in between and floor panel and the floor this distance can protect the panel from water or any other objects that damage the panel. And the final step is to create the cut-outs for electrical wires. To make a perfect cut out measure across the point by end of the panel and nearer and also far aside from the electrical object. Measure and mark the right position if your marking area differs from the measured area while fixing the wire you will get disturbed. These are the steps to be followed to install drywall using drywall screws.