How to wrap a hockey stick and work on its size

Do not destroy your new hockey equipment by bad treatment. The experts send you in the majority with tips and tricks on how to maintain the hockey equipment so that it will last as long as possible to the satisfaction of you and your family fund. The experts present you the different ways of wrapping the blade and the upper end of the racket. At the end of the series, we’ll tell you what a grip is and how to make it. If you need to select a hockey stick first, the experts can help you to advise about Ice hockey Equipment .

Cut it properly

When you buy your hockey stick, you need to trim its length to your size. The easiest step is simply cutting the bat. The golden rule is that the hockey stick should reach out to your nose when you are barefoot.

Forward players will like to cut their hockey sticks lower, so you can better mix and maneuver with the puck in the corner at the gang. Defenders, on the other hand, cut the clubs higher to keep going with them. Never go for extremes where you cut the bat by a dozen centimeters. The end of the hockey stick should not be further from your nose than a maximum of 2-3 cm.

Types of ribbons

The hockey stick you have prepared exactly to your size, and it has come the time to change the racket. As with the trowel, so also at the upper end of the racket exist several species. When tying the trowel, it is most common to proceed from the foot to the end of the trowel. They tape the top of the racket with the tape and then the whole trowel.

Thanks to this type of binding you will get the friction on the whole surface of the trowel, and the puck will not slip from it. But the trowel is heavier after wrapping. If you want to make the trowel lighter, use ribbons along with the trowel. They perform the same function in friction, but the band is less, the trowel is lighter and slides better on the ice.

The types of binding

At the top end of the racket, two types of binding are most common. Either the grip tape has only one layer, or it is multi-layered. If the grip band has only one layer, wrap it around the top of the racket. They gain the necessary friction, the band does not change the shape of the racket, and it does not make it any harder. Nevertheless, it does not protect your palm from sharp edges, which you will not only feel on the hand but also on the surfaces of the gloves.

A multi-layered grip changes the shape of the racket and makes it heavier. Rewarding you will be more protection for your hands, and the hockey stick will be less likely to fall out of your hands. Bind the racket so that you wrap the twine on the upper part of the racket and form the desired shape. There is no rule for the right form because everyone has something different. Then cover with a layer of the upper part of the hockey stick as in the first case.